ROK-ON™ Building Systems manufactures green building products that allow contractors/builders to meet new mandatory fire and ... energy codes with structural products that are fire, rot, mold and termite resistant that greatly improve the energy efficiency of buildings installed which is installed in 50% less time compared to traditional code compliant wall assemblies. The company's focused on providing a high-performance, lower-cost solution for exterior walls, which exceed the North American building codes for energy and fire performance. Our proprietary fiberglass reinforced ceramic cement sheathing is laminated to EPS foam to create a thin structural panel that is attached directly to framing as the exterior insulated sheathing. The product is non-combustible, will not rot, will not support mold or mildew, is water resistant, impact resistant, and bug proof. It requires no special tools to install and contains no harmful ingredients. The system can accept direct application of finishes such as stucco, metal panels, brick, stone, veneers, etc., allowing for tremendous architectural flexibility while saving time and money. We're fully tested to meet or exceed all 2015 IBC building codes and fully insured. Most importantly, the system replaces several layers and steps required in other wall systems to be code compliant. It can be fully installed and finished in just 3 steps, versus the 8-11 steps of a traditional EIFS system. ROK-ON™ can be installed on a frame in about the same time as just the Dens Glass® (or other first layer of sheathing) and is then finished directly. This saves a tremendous amount on labor, and can subtract weeks/months off the construction timeline, outside of prefabrication. Moreover, our systems ideal to manufacture prefabricated wall assemblies. Prefabrication can significantly reduce the construction time & lead to earlier occupancy. We have factories near you. See our website for information & videos. www.rok-on.com read more